TROUBLE SHOOTING

If your Servo Voltage Stabilizer does not operate properly, please check the following points before calling for service

SYMPTOM	CAUSE	REMEDY
No output	No input supply	Call your Electrician
	Incoming voltage is out of range. Servo may be in  cut-off mode.	Use By-Pass mode
	MCB / Fuse may be shut off / blown Due to Over  Loading	Check your load
High / Low Output Contact our  Service Voltages	Input Voltage out of range	Contact our Service  Engineer
	Problem in Control Circuit	Contact our Service  Engineer

SAFETY INSTRUCTIONS

1. The stabilizer should be installed in a fairy cool and well ventilated place.
2. It should be kept above the floor level as far as possible.
3. The chassis of the stabilizer must be connected to the earthing of the supply.
4. The unit should be installed at the place protected from rain and water